Caldera Paradise Series User Manual download pdf (Page 12)

MAINTENANCE

3 days a week Check water level. Make certain water level is 1 inch above the

highest jet.

Check and adjust Chlorine level to 1.0 to 3.0 ppm if Chlorine is

used as sanitizer. If Bromine is used, check weekly.

Once a week Test the spa water using test strips or test kit.

Adjust pH and total alkalinity - refer to pH and total alkalinity on

label of SPA UP and SPA DOWN.

Check and adjust Bromine level to 1.0 to 3.0 ppm if Bromine is

used as sanitizer. If Chlorine is used, check three times a week.

Add 1 ounce of SPA DEFENDER per 400 gallons of water to

prevent calcium build up.

Shock treat with 2 ounces of RENEW, a non-chlorine shock.

Check and clean the skimmer basket and weir to insure proper

filter flow, remove leaves, foreign matter and debris.

Check spa cover. Make certain cover is positioned properly and

tie-down straps are fastened/locked. Be sure water and snow are

swept off or kept from accumulating or puddling on the cover.

Four to six weeks

Inspect and clean the spa filter cartridge. It is very important to

maintain your spa filter cartridge and keep it clean and free of particles

which can restrict water flow. If the filter is not cleaned on a regular

basis, the filter may clog and restrict water flow, which causes improp-

er filtration and poor jet performance. See “ FILTER CARTRIDGE

REMOVAL AND CLEANING INSTRUCTIONS” on page 12.

Two months (heavy usage)

Drain your spa. Follow the procedures outlined in “DRAINING

Five months (light usage) YOUR SPA” on page 16. Clean the spa with “Spa Multi-Purpose

Cleaner” and then polish with a silicone sealant polish. When refilling

your spa be sure to follow the “START-UP” instructions on page 5.

Six months Clean and seal your spa skirt. The spa skirt is coated with a

tinted stain for protection and to enhance the beauty of the natural

redwood. Like all wood products, prolonged exposure to the

weather and climate conditions will cause the redwood to discolor

or fade. To maintain the rich finish, apply a good quality tinted or

clear stain every six months.

Note: The stain used by Caldera is available from your Caldera

dealer.

IMPORTANT MAINTENANCE PROCEDURES

Page 10

IMPORTANT:

KEEP SAND AND GRIT OUT OF SPA

Sand and grit will damage or impair the

performance of your spa’s components.

Use caution to avoid tracking debris into

the spa. Remove sand or grit from the

spa as soon as you notice it is present.

A spa vacuum designed for this purpose

is available from your Caldera dealer.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Caldera Paradise Series User Manual Page 12

Comments to this Manuals

Related products and manuals for Kitchen Caldera Paradise Series